Corona Pool Builders provides professional water features & fountains in Corona, CA for residential and commercial properties across the Inland Empire. Pool water features are the addition that most changes the character of a Corona backyard during a remodel, and they do two practical things alongside looking good. They mask road noise, which matters on the many properties within earshot of the 91 or the 15, and they aerate, which is the only genuinely effective way to pull heat out of a pool that has been sitting in triple-digit sun all week. A waterfall running overnight will drop the water temperature by several degrees by morning. Sheer descents are the workhorse: a stainless or acrylic weir set into a raised wall, dropping a flat sheet of water into the pool, backlit with color-changing LED. They move a lot of water, which makes them the best cooling feature as well as the most architectural. Laminar jets throw a clear arc across the deck and no child will leave them alone. Bubblers on a tanning ledge are inexpensive, quiet, and the feature toddlers actually use. Scuppers set into a stuccoed raised bond beam suit the Spanish and Mediterranean elevations that dominate the housing stock here. Boulder waterfalls and grottos still work on the larger hillside lots in South Corona and out along Temescal Canyon where the scale supports them. Hydraulics decide whether a feature performs or embarrasses itself, and retrofitting into an existing pool is where this gets real. Every feature needs its own plumbing run sized to the weir width, with enough head pressure to deliver the design flow, which usually means either a dedicated feature pump or a saved speed on a variable-speed pump. On a remodel we can often route new feature plumbing while the deck is already open, which is dramatically cheaper than opening it later — one of several reasons to decide about features before the deck goes back down rather than after. We also repair existing features: leaking waterfall basins, dead bubblers, seized feature pumps, and rockwork that has gone slick and green.
With 15+ years of experience, our licensed and insured team brings the right materials and equipment to every job — PebbleTec and pebble aggregate interiors, polished quartz resurfacing, full chip-out and bond beam repair, glass mosaic waterline tile, travertine and porcelain coping, Title 24 variable-speed pumps — and backs the work with a written workmanship warranty. We serve Corona and nearby communities including Riverside, Moreno Valley, Ontario, Rancho Cucamonga.
What We Handle
Everything our water features & fountains in Corona covers
One crew, one point of contact, and the full range of water features & fountains work in Corona, CA. If it is on this list we do it in house rather than handing it to a subcontractor:
- sheer descent waterfalls
- rock waterfall construction
- bubblers and deck jets
- laminar jets with LED
- scupper and spillway features
- grotto features
- raised wall water features
- pool fountain repair
- water feature pump sizing
- aeration for pool cooling
- negative edge and perimeter overflow
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Corona services.
Materials, equipment and how we do water features & fountains
The difference between water features & fountains that lasts and water features & fountains that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with PebbleTec and pebble aggregate interiors, polished quartz resurfacing, full chip-out and bond beam repair, glass mosaic waterline tile, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Corona job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. 15+ years of pool work in the Inland Empire means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do water features & fountains outside Corona
Corona Pool Builders covers Corona and the surrounding communities of the Inland Empire. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Water Features & Fountains in Riverside, CA — Riverside County, population 315,000
- Water Features & Fountains in Moreno Valley, CA — Riverside County, population 208,600
- Water Features & Fountains in Ontario, CA — San Bernardino County, population 175,300
- Water Features & Fountains in Rancho Cucamonga, CA — San Bernardino County, population 174,500
- Water Features & Fountains in Murrieta, CA — Riverside County, population 110,900
- Water Features & Fountains in Temecula, CA — Riverside County, population 110,000
Start on the Corona Pool Builders homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Corona Chooses Corona Pool Builders
- ✓Remodeling and resurfacing specialists — it is most of what we do, not a sideline
- ✓Over 15 years across Corona, Norco, Eastvale and the Temescal Valley
- ✓Honest shell inspection before you spend a dollar on finishes
- ✓Full chip-out prep, not a bond coat over a failing surface
Every water features & fountains project in Corona gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free water features & fountains free estimate in Corona, or request a quote and we'll get right back to you.